Our digital depth gages inspect the location of internal and external shoulder and grooves from the face of pin and box connections or other datum surfaces. The DG-1000 Series is available with the standard base, a 12″ base, and a 20″ base. These gages are available in ranges: 0 – 8”, 0 – 12″, 0 – 18″, and 0 – 24″.
The standard gage (DG-1000 Series) is supplied with a 7” extension arm and a 0° and 45° contact point holder for use with any #4-48 threaded contact point (one .072″ contact point (T072) supplied unless otherwise requested). Longer extension arms and other contact point configurations and adapters are available upon request. The 12″ (DG-1200 Series) and 20″ (DG-2000 Series) gages include one double sided blade contact instead of a contact point and a contact point holder.
Digital depth gages do not requires a setting standard. The gage is preset to zero on any flat surface and then applied to the product. Actual length measurements display on the gage’s digital readout.
- Inspect internal an external shoulder and groove locations.
- Uses an interchangeable contact point or blade that can service many different applications.
- Inch/metric conversion with digital readout
- Digital readout with .0005″/.01 mm resolution and SPC Output
|0” – 12” (0 mm – 304.8 mm)||.0005”/.01 mm||20" Base Digital Depth Gage||DG-2012|
|0” – 18” (0 mm – 457.2 mm)||.0005”/.01 mm||20" Base Digital Depth Gage||DG-2018|
|0” – 24” (0 mm – 609.6 mm)||.0005”/.01 mm||20" Base Digital Depth Gage||DG-2024|
Torque Shoulder Length
Both the TS-1000 and TS-4000 series of gages accurately measure the distance between the primary and secondary torque shoulders on both internal and external threaded connections. Used industry wide to measure the shoulder-to-shoulder distance on premium tool joins and the face-to-seal location on premium couplings, Gagemaker TS gages are also perfectly suited to locate grooves from various datum surfaces.
All TS gages require a setting standard. The gage is preset to the desired dimension and deviation is read from the gage’s dial indicator. Standards are sold separately.
The TS-1000 is supplied with a 6″ extension arm. A 45° contact point holder for use with any #4-48 threaded contact point is also supplied. Longer extension arms, other contact points, and adapters are available upon request.
TS-4000 gages require taper specific wear pads that are sold separately.
- Inspects internal and external shoulder and groove locations
- Uses an interchangeable contact point that can service many different applications
*Taper is specified for design purposes and proper wear pads. Wear pads are sold separately.