Gage Tip of the Month

March 2017

When using an MRP to inspect a coupling’s Pitch Diameter, mark the location of the MRP on the face of the 1st machined part, and record the gage reading. Leave this 1st machined part nearby to verify between each additional machined coupling that the gage is still set properly.

Gage Tip of the Month

June 2016

An easy adjustment of your rails during assembly of an MRP-2001 will help you see the indicator better when inspecting external crest diameter, pitch diameter, or ovality. During setup, you simply position the rails so that any excess rail over-hang exists on the “fixed end”(the end not holding the indicator). Below you’ll find video instructions […]